What am I missing?

Post by **Kent Briggs** » Thu Jan 15, 2009 12:54 am

SVTF wrote:
Kent Briggs wrote:
SVTF wrote:It just times out for me?
Are you inside your own network? If so, try connecting to your local IP + file port.
That did it ... Thanks.

So on the old router also inside my own network I connected via Internet IP for over a year?

Is it because the there might be a different setting in the router?

It might be a firewall issue. I seem to remember not being able to use my internet ip inside my own network once. I think it was Zone Alarm screwing me up and not the Linksys router. I can't remember now.

SVTF · Post by **SVTF** » Thu Jan 15, 2009 1:00 am

Well thanks for your help.

SVTF · Post by **SVTF** » Fri Dec 30, 2011 10:08 pm

Kent,

Dusting off Mavens ... Its been a while since I have started it up.

Just updated the version and well ... the port forwarding is all set up in the router.

And I can connect via my internal ip and log in etc.

But I can not see my table listed at www.pokermavens.net?

Any advise?

SVTF · Post by **SVTF** » Fri Dec 30, 2011 10:23 pm

SVTF wrote:Kent,

Dusting off Mavens ... Its been a while since I have started it up.

Just updated the version and well ... the port forwarding is all set up in the router.

And I can connect via my internal ip and log in etc.

But I can not see my table listed at http://www.pokermavens.net?

Any advise?

I think I may have found the fix for this ... testing it now ... I see my server listed on pokermavens now.

Post by **Kent Briggs** » Fri Dec 30, 2011 10:43 pm

Just set the "Directory listing" property to Yes in the Site Information group. If you set a password for your site then you'll appear on the Private tab.

SVTF · Post by **SVTF** » Fri Dec 30, 2011 10:45 pm

Kent Briggs wrote:Just set the "Directory listing" property to Yes in the Site Information group. If you set a password for your site then you'll appear on the Private tab.

Ok this seems to be working now ...

But someone just created a new account and it would not send the validation code ... any thoughts?

Post by **Kent Briggs** » Fri Dec 30, 2011 11:35 pm

SVTF wrote: But someone just created a new account and it would not send the validation code ... any thoughts?

That's controlled by the SMTP settings. Check all of those. The FAQ includes instructions for using Google's mail server if you don't have your own:

http://www.briggsoft.com/pmfaq.htm

Briggs Softworks

What am I missing?

Re: What am I missing?

Re: What am I missing?

Re: What am I missing?

Re: What am I missing?

Re: What am I missing?

Re: What am I missing?

Re: What am I missing?